Logic Pro for Mac 12.3
Logic Pro for Mac 12.2
Logic Pro for Mac 12.0
Logic Pro for Mac 11.2
Logic Pro for Mac 11.1
Logic Pro for Mac 11.0
Logic Pro for Mac 10.8
Logic Pro for Mac 10.7.8
Logic Pro 10.7.5
Logic Pro 10.7.3
Logic Pro 10.7
Logic Pro 10.6.2
Logic Pro 10.6
Logic Pro X 10.5
سيؤدي تعديل زر التحكم إلى إعادة تحميل هذه الصفحة تلقائيًا

Edit comps in Logic Pro

You can edit comps by changing the start or end point of take sections, by moving a selected comp area to the left or right, or by alternating selected comp areas between takes. You should save a comp before editing it. Any subsequent changes automatically create a new comp.

Edit sections of different take regions

In Logic Pro, do one of the following:

  • To extend a take section: Place the pointer over the start or end point of a take selection, then drag.

    Figure. Dragging the end point of a take selection.

    Extending a take selection (dragging the start point to the left or the end point to the right) shortens adjacent selections on other takes. Shortening a take selection (dragging the start point to the right or the end point to the left) extends adjacent selections on other takes. This ensures that you don’t create silence between take selections.

  • To shorten a take section: Place the pointer over the start or end point of a take selection, then Shift-drag.

    Figure. Shift-dragging the end point of a take selection.

    Shortening a take selection (dragging the start point to the right or the end point to the left) does not extend adjacent selections on other takes. This allows you to create silence between take selections.

Note: If you have enabled Quick Swipe / Take Edit click zones in Preferences > General > Editing, make sure you place the pointer over the bottom half of the take region.

Move a selected area to the left or right

  • In Logic Pro, place the pointer over the center area of a take selection, then drag when the pointer changes to a two-headed arrow.

    Figure. Dragging the center area of a take selection.

This action moves the selection, while at the same time extending or shortening any adjacent take selections.

Note: If you have enabled Quick Swipe / Take Edit click zones in Preferences > General > Editing, make sure you place the pointer over the bottom half of the take region.

Alternate selected areas between take lanes

  • In Logic Pro, click an unselected area of a take to make that particular area active and part of the comp.

    Figure. Clicking an unselected area of a take.

The same area is automatically deselected in another take. This is a quick way to compare a section of two different takes.

Note: If you have enabled Quick Swipe / Take Edit click zones in Preferences > General > Editing, make sure you place the pointer over the bottom half of the take region.

Remove a take selection from the comp

  • In Logic Pro, shift-click the take selection.

    Figure. Shift-clicking a selected area of a take.

Remove an entire take from the comp

  • In Logic Pro, shift-click the take’s header area.

    Figure. Shift-clicking a take’s header area.

If the take doesn’t contain any selections, all unselected areas in other takes are selected in the take you click.

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
هل كان هذا مفيدًا؟
الحد الأقصى للأحرف: 250
الحد الأقصى للأحرف 250.
شكرًا على ملاحظاتك.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.