Logic Pro for iPad 3.3
Logic Pro for iPad 3.0
Logic Pro for iPad 2.2
Logic Pro for iPad 2.1
Logic Pro for iPad 2.0
Logic Pro for iPad 1.1
Logic Pro for iPad 1.0
ഈ കൺട്രോളിൽ മാറ്റം വരുത്തുന്നത് ഈ പേജ് ഒട്ടോമാറ്റിക്കായി അപ്ഡേറ്റ് ചെയ്യാനിടയാക്കും

Sculpture MIDI controller assignments in Logic Pro for iPad

The Sculpture MIDI controller assignment parameters let you define MIDI controllers—for vibrato depth control or Morph Pad movements, for example. You can use any MIDI controller shown in the menus for these control sources.

These parameters are saved with each setting. They are updated only if the default setting that is loaded on instantiating the plug-in is used, or if the setting was saved with a project. This approach helps you to adapt all MIDI controllers to the keyboard without having to edit and save each setting separately.

Tap the Misc button at the top of the plug-in to view and adjust these Sculpture parameters.

Figure. Controller section.

MIDI controller parameters

  • Vibrato Ctrl pop-up menu: Choose the MIDI controller used for vibrato depth control.

  • Ctrl A/B Assign pop-up menus: Choose two controllers that can be used for side chain modulations or as via modulation sources, as set in the CtrlA and CtrlB modulation routing views.

  • EnvCtrl 1/2 Assign pop-up menus: Choose controller assignments for the two control envelopes, which can be used as a modulation signal or an offset. Offsets occur in cases where the control envelope is set to Ctrl only or Ctrl+Env modes. These assignment pop-up menus also define the source for recording controller movements.

  • Morph X/Y Assign pop-up menus: Choose controller assignments for the x and y coordinates of the Morph Pad. After they are assigned, you can use the controller to manually move the morph point, program single Morph Envelope points, shift the entire Morph Envelope, and serve as a source for recording morph movements.

  • Ctrl Ass(ignment) handling menu: Choose either the default MIDI controller assignments or controller assignments loaded from the setting. If you choose Use Default, assignments remain unchanged. If you choose Load From Setting, you use the controller assignments you saved with the setting. (The default assignments are taken from the #default.pst setting, if it exists, which is loaded when Sculpture is inserted into an instrument channel strip.)

Learn a MIDI controller assignment in Sculpture

  1. In Logic Pro, open a controller assignment pop-up menu, and choose the Learn item.

  2. Move the controller on your MIDI keyboard or MIDI controller.

    Note: If no suitable MIDI message is received within 20 seconds, the selected control reverts to the previous value or assignment.

Download this guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
സഹായകമായോ?
കാരക്റ്റർ പരിധി: 250
പരമാവധി കാരക്റ്റർ പരിധി 250 ആണ്.
നിങ്ങളുടെ ഫീഡ്ബാക്കിന് നന്ദി.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.