Learn to design and build an 4 channel LM35 temperature sensor chip Signal conditioner amplifier circuit based on the popular opamp LM324 using Kicad 6.0.The board can be used to monitor temperature from 4 different sources at the same time and can be used for building your own data acquisition system.

This repository contains the files (schematic, test bench, simulation results) from the course Mixed-Signal Design(undergrad)

Design of Differential Input Single Ended Output Single Stage Amplifier

Design of a two-stage microwave balanced amplifier implemented with microstrip technology

Design of a common source amplifier using Skywater sky130 technology

A monaural class AB audio amplifier

Designed an ultra-low-power Miller OTA in 90-nm GPDK using 500 mV supply. Used bulk-driven input pair and level shifters for rail-to-rail operation. Achieved 40 dB gain, 127.4 kHz UGF, 70.47° phase margin, 0.04–0.486 V swing, and 2.31 µW power.

Hey! This code provides a set of tools to characterize Amplifiers in emisor or base common configuration, this is done by providing it a set of parameters (VCC, R, HF). And it's able to use 1, 2 or 3 resistors in the voltage divisor.

Class AB (headphone) amplifier for FlexRadio project.

Optimization of CMOS-based amplifier circuit that converges to the optimal solution in very less time. Differential evolution is used in this optimization.