Ti-Ez430 Firmware
- Accelerometer sensor & module
- Rf PPT, SYNC, ACC modes
- Alarm module
First you need to configure the firmware:
make config
Then:
make
The compiled files are in build/ and the current configuration is in config/.
Now you need to install the generated build/openchronos.txt on the watch. Do:
make install (method=usb)
By default it install the firmware on the watch using the rf dongle. With "method=usb" it will use the usb dongle and prog the watch with "mspdebug".
To clean the generated files of the build:
make clean
To clean everything generated (build & config files):
make clear
To create the Doxygen documentation from source code:
make doc
Also:
make run
make debug
You can debug the firmware by connecting the watch in usb. You also need to enable DEBUG in "make config".
Then launch this:
make debug
nemiver --remote=127.0.0.1:2000 --gdb-binary=/usr/local/bin/msp430-gdb build/openchronos.elf
You can now open the source files and add breakpoints, ...
The first command start gdb of the watch and allow remote connections to it. The second one start the graphical debugger named "Nemiver" and connect it directly to gdb.