I've been running into some 030 errors on the micro:bit V2 recently (microbit-foundation/micropython-microbit-v2#228) which I believe are from the underlying codal layer. Is there any (easy!) way to have this displayed for 60 seconds and then automatically restart MicroPython as if the reset button had been pressed? Or just restart? That would allow my program to recover (as a workaround) and for my particular application that would be a reasonable solution.

While I'm here does anyone know of a bit of hardware that can sit inbetween a micro:bit's edge connector and a socket to allow access to the pins for troubleshooting? I've only found the ElecFreaks edge:bit so far and I've found it in stock so far...

I noticed this forum area is called nRF. This might not be obvious for novices seeking to post questions about MicroPython on the micro:bit (V1 and V2).