Designed for environmental monitoring, Enviro+ lets you measure air quality (pollutant gases and particulates), temperature, pressure, humidity, light, and noise level. Learn more - https://shop.pimoroni.com/products/enviro-plus

You're best using the "One-line" install method if you want all of the UART serial configuration for the PMS5003 particulate matter sensor to run automatically.

Note The code in this repository supports both the Enviro+ and Enviro Mini boards. The Enviro Mini board does not have the Gas sensor or the breakout for the PM sensor.

curl -sSL https://get.pimoroni.com/enviroplus | bash

Note report issues with one-line installer here: https://github.com/pimoroni/get

• git clone https://github.com/pimoroni/enviroplus-python
• cd enviroplus-python
• sudo ./install.sh

Note Raspbian Lite users may first need to install git: sudo apt install git

• Run sudo pip install enviroplus

Note this wont perform any of the required configuration changes on your Pi, you may additionally need to:

• Enable i2c: raspi-config nonint do_i2c 0
• Enable SPI: raspi-config nonint do_spi 0

And if you're using a PMS5003 sensor you will need to:

• Enable serial: raspi-config nonint set_config_var enable_uart 1 /boot/config.txt
• Disable serial terminal: sudo raspi-config nonint do_serial 1
• Add dtoverlay=pi3-miniuart-bt to your /boot/config.txt

And install additional dependencies:

sudo apt install python-numpy python-smbus python-pil python-setuptools

• GPIO Pinout - https://pinout.xyz/pinout/enviro_plus
• Support forums - http://forums.pimoroni.com/c/support
• Discord - https://discord.gg/hr93ByC