Introduction The btrfs filesystem has taunted the Linux community for years, offering a stunning array of features and capability, but never earning universal acclaim. Btrfs is perhaps more deserving of patience, as its promised capabilities dwarf all peers, earning it vocal proponents with great influence. Still, none can argue that btrfs is unfinished, many features are very new, and stability concerns remain for common functions.

Killing Zombies! Also known as “defunct” or “dead” process – In simple words, a Zombie process is one that is dead but is present in the system’s process table. Ideally, it should have been cleaned from the process table once it completed its job/execution but for some reason, its parent process didn’t clean it up properly after the execution.

Update: As of September 22nd, 2020, Linux Journal is back under the ownership of Slashdot Media. IMPORTANT NOTICE FROM LINUX JOURNAL, LLC:

  If you've written any amount of bash code, you've likely come across the trap command. Trap allows you to catch signals and execute code when they occur. Signals are asynchronous notifications that are sent to your script when certain events occur. Most of these notifications are for events that you hope never happen, such as an invalid memory access or a bad system call. However, there are one or two events that you might reasonably want to deal with. There are also "user" events available that are never generated by the system that you can generate to signal your script. Bash also provides a psuedo-signal called "EXIT", which is executed when your script exits; this can be used to make sure that your script executes some cleanup on exit.

Doc Searls and Katherine Druckman talk to Yiftach Shoolman of Redis Labs about Redis, Open Source licenses, company culture and more. Listen to the podcast here.

Steven Rostedt wanted to do a little housekeeping, specifically with the function tracing code used in debugging the kernel. Up until then, the kernel could enable function tracing using either GCC's -pg flag or a combination of -pg and -mfentry. In each case, GCC would create a special routine that would execute at the start of each function, so the kernel could track calls to all functions.