修改此控制項目會使頁面自動更新

Adjust a replicator from the HUD in Motion

When you create a replicator from a source layer, the onscreen pattern is built using the default parameters in the Replicator Inspector and Replicator Cell Inspector. You can modify the most important of these parameters in Replicator HUD and the Replicator Cell HUD. The HUD also provides quick access to the Opacity and Blend Mode parameters, located in the Properties Inspector.

Adjust a replicator in the Replicator HUD

  1. In the Layers list or Timeline in Motion, select a replicator.

    The HUD appears. (If it does not appear, press F7.)

  2. Modify any of the controls in the HUD: Opacity, Blend Mode, Shape, Arrangement, Columns, Rows, or Origin.

    These controls are a subset of the controls in the Replicator Inspector and in the Properties Inspector. See Replicator controls and Adjust additional replicator properties.

Adjust a cell in the Replicator Cell HUD

  1. In the Layers list or Timeline in Motion, select a replicator cell.

    The HUD appears. (If it does not appear, press F7.)

  2. Modify any of the controls in the HUD: Angle, Angle End, Angle Randomness, Scale, Scale End, or Scale Randomness.

    These controls are a subset of the controls in the Replicator Cell Inspector. See Replicator cell controls.

Download this guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
有幫助?
字元限制: 250
字元數目上限為 250。
感謝您提供意見。
Morty Proxy This is a proxified and sanitized view of the page, visit original site.