Logic Pro for Mac 12.3
Logic Pro for Mac 12.2
Logic Pro for Mac 12.0
Logic Pro for Mac 11.2
Logic Pro for Mac 11.1
Logic Pro for Mac 11.0
Logic Pro for Mac 10.8
Logic Pro for Mac 10.7.8
Logic Pro 10.7.5
Logic Pro 10.7.3
Logic Pro 10.7
Logic Pro 10.6.2
Logic Pro 10.6
Logic Pro X 10.5
修改此控制項目會使頁面自動更新

Set audio file levels in Logic Pro

You can use the Change Gain command to change the level of an audio file in the Audio File Editor. Typically used on an entire audio file, this command can also be used to boost portions of it.

Raise or lower the level of the selected audio file (or area) by a specific amount

  1. In Logic Pro, choose Functions > Change Gain from the Audio File Editor menu bar.

  2. Choose your settings in the Change Gain dialog:

    Figure. Change Gain dialog.

    • Set the required level change in the Change Relative fields by clicking the up or down arrows, or by directly entering values, in either field. You can use the percentage or decibel field to indicate the amount of increase or decrease you prefer.

    • Click the Search Maximum button to search for the peak level. This automatically sets a value that is used to alter the level of the audio file. The Results in Absolute fields display the maximum level that is achieved by changing the gain—by the amount shown in the Change Relative fields.

  3. Click Change to perform the gain change.

Important: You should never make a gain change that results in a value over 100%, because this results in digital clipping.

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
有幫助？
字元限制： 250
字元數目上限為 250。
感謝您提供意見。
Morty Proxy This is a proxified and sanitized view of the page, visit original site.