Logic Pro for Mac 12.3
Logic Pro for Mac 12.2
Logic Pro for Mac 12.0
Logic Pro for Mac 11.2
Logic Pro for Mac 11.1
Logic Pro for Mac 11.0
Logic Pro for Mac 10.8
Logic Pro for Mac 10.7.8
Logic Pro 10.7.5
Logic Pro 10.7.3
Logic Pro 10.7
Logic Pro 10.6.2
Logic Pro 10.6
Logic Pro X 10.5
修改此控制項目會使頁面自動更新

Logic Pro AutoFilter envelope controls

The envelope is used to shape the filter cutoff over time. When the input signal exceeds the set threshold level, the envelope is triggered.

Figure. Envelope parameters.

Envelope parameters

  • On/off switch: Turn the envelope section on or off.

  • Threshold knob and field: Set an input level that—if exceeded—triggers the envelope or LFO that dynamically modulates filter cutoff frequency. See Logic Pro AutoFilter LFO controls and Logic Pro AutoFilter filter controls.

    Note: Retriggering of the envelope or LFO occurs only if the Retrigger button is active.

  • Dynamic knob and field: Determine the input signal modulation amount. You can modulate the peak value of the envelope section by varying this control.

  • Attack handle and field: Drag the handle horizontally (or field vertically) to set the envelope attack time.

  • Decay handle and field: Drag the handle horizontally (or field vertically) to set the envelope decay time.This handle sets both the decay time and sustain level.

  • Sustain handle and field: Drag the handle (or field) vertically to set the envelope sustain level. If the input signal falls below the threshold level before the envelope sustain phase, the release phase is triggered.

  • Release handle and field: Drag the handle horizontally (or field vertically) to set the envelope release time. This is triggered as soon as the input signal falls below the threshold.

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
有幫助？
字元限制： 250
字元數目上限為 250。
感謝您提供意見。
Morty Proxy This is a proxified and sanitized view of the page, visit original site.