Logic Pro for iPad 3.3
Logic Pro for iPad 3.0
Logic Pro for iPad 2.2
Logic Pro for iPad 2.1
ఈ కంట్రో‌ల్‌ను మారిస్తే, ఈ పేజీ ఆటోమేటిక్‌గా అప్‌డేట్ చేయబడుతుంది

EnVerb in Logic Pro for iPad

EnVerb is a versatile reverb effect with a unique feature: it allows you to adjust the envelope—the shape—of the diffuse reverb tail.

  • Delay parameters: These controls determine the timing of the dry signal and the first reflection.

  • Envelope parameters: You can adjust levels over time (the envelope) of the reverb. You can control the delay time of the original signal and can change the reverb tail over time.

  • Reverberator parameters: You can shape the sound of the reverb signal. You can split the incoming signal into two bands with the Crossover parameter and can set the low frequency band separately.

  • Output parameters: These controls set the overall output level.

To add EnVerb to your project, choose Reverb > EnVerb in a channel strip Audio Effect plug-in menu or the Plug-ins area. See Intro to plug-ins. Also see Add, replace, reorder, and remove plug-ins in the Plug-ins area and Work with plug-ins in the Mixer.

Figure. EnVerb window, showing mix, sound, and time parameters.

EnVerb Delay and Envelope parameters

  • Dry Signal Delay knob and field: Determine the delay of the original signal. Set a suitable level with the Dry slider in the Mix section.

  • Predelay knob and field: Set the time between the original signal and the start point of the reverb attack phase—the very beginning of the first reflection.

  • Attack slider and field: Set the time it takes for the reverb to climb to its peak level.

  • Decay slider and field: Set the time it takes for the level of the reverb to drop from its peak to the sustain level.

  • Sustain slider and field: Set a constant reverb level for the sustain phase. It is expressed as a percentage of the full-scale volume of the reverb signal.

  • Hold slider and field: Set the duration of the reverb sustain phase.

  • Release slider and field: Set the time it takes for the reverb to fade out completely, after the sustain phase.

EnVerb Reverberator and Output parameters

  • Density knob and field: Set the reverb density.

  • Spread knob and field: Control the width of the reverb stereo image. At 0% the effect generates a monaural reverb. At 200% the stereo base is artificially expanded.

  • Low Freq Level knob and field: Set the relative level of (reverb signal) frequencies below the crossover frequency. In most cases you get better-sounding results when you set negative values for this parameter.

  • Crossover knob and field: Set the frequency used to split the input signal into two frequency bands for independent processing.

  • High Cut knob and field: Filter reverb tail frequencies above the value set with the Crossover knob.

  •  Dry/Wet controls and fields: Determine the balance between the effect (wet) and direct (dry) signals.

Download this guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
ఉపయోగకరంగా ఉందా?
అక్షరాల పరిమితి: 250
అక్షరాల గరిష్ట పరిమితి 250.
మీ ఫీడ్‌బ్యాక్ అందించినందుకు ధన్యవాదాలు.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.