Logic Pro for Mac 12.3
Logic Pro for Mac 12.2
Logic Pro for Mac 12.0
Logic Pro for Mac 11.2
Logic Pro for Mac 11.1
Logic Pro for Mac 11.0
Logic Pro for Mac 10.8
Logic Pro for Mac 10.7.8
Logic Pro 10.7.5
Logic Pro 10.7.3
Logic Pro 10.7
Logic Pro 10.6.2
Logic Pro 10.6
Logic Pro X 10.5
Po úprave tohto ovládacieho prvku sa táto stránka znova načíta

Delay lines in the Logic Pro Environment

A delay line object repeats (echoes) MIDI events passing through it, at intervals ranging from one tick to 256 whole notes.

Figure. Environment window showing a delay line object and its inspector.

Create a new delay line object

  • In Logic Pro, choose New > Delay Line.

As with the arpeggiator, you need to place a delay line object in the MIDI signal path, and Logic Pro must be in playback mode. The echoes of each incoming event are sent, sequentially, to each cabled output of the delay line object: event 1 to cable 1, event 2 to cable 2, and so on. Obviously, if only one cable is connected, then all events are sent to that output.

The delay line can send up to 99 repeats, at intervals ranging from one tick to 256 whole notes. You can also suppress the original note events.

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Boli tieto informácie užitočné?
Maximálny počet znakov: 250
Maximálny počet znakov je 250.
Ďakujeme vám za pripomienky.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.