11.2
11.0
10.7.3
10.6
10.5
A vezérlőelem módosítása esetén újratöltődik az oldal

M-Audio iControl locators and Cycle mode in Logic Pro

The left and right locators are used to mark a section of your Logic Pro project. These are often used in conjunction with cycle facilities, which repeatedly play back the section of your project between the locators.

Set left and right locators and turn on Cycle mode

  1. Use the jog wheel to move the playhead to the left locator position, then press both the Cycle and Rewind buttons.

  2. Do one of the following:

    • Navigate to the position where you want to set the right locator with the jog wheel, then press the Cycle and Fast Forward buttons simultaneously.

    • Hold down the Cycle button, navigate to the position where you want to set the right locator using the jog wheel, then release the Cycle button.

    • Rotating the jog wheel counterclockwise (to the left) while holding down Cycle defines a skip-cycle range.

Download the guides:

Logic Pro User Guide: PDF

Logic Pro Instruments: PDF

Logic Pro Effects: PDF

Control Surfaces Support Guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Hasznos?
Karakterkorlát: 250
A maximális karakterkorlát 250.
Köszönjük a visszajelzést!
Morty Proxy This is a proxified and sanitized view of the page, visit original site.