Logic Pro for iPad 3.3
Logic Pro for iPad 3.0
Logic Pro for iPad 2.2
Logic Pro for iPad 2.1
Logic Pro for iPad 2.0
Logic Pro for iPad 1.1
Logic Pro for iPad 1.0
Εάν τροποποιήσετε αυτό το χειριστήριο, θα γίνει αυτόματη ενημέρωση αυτής της σελίδας

SubBass in Logic Pro for iPad

SubBass generates frequencies below those of the original signal, resulting in artificial bass content. The simplest use for SubBass is as an octave divider, similar to octaver effect pedals for electric bass guitars. Whereas such pedals can only process a monophonic input sound source of clearly defined pitch, SubBass can be used with complex summed signals as well.

To add SubBass to your project, choose Specialized > SubBass in a channel strip Audio Effect plug-in menu or the Plug-ins area. See Intro to plug-ins. Also see Add, replace, reorder, and remove plug-ins in the Plug-ins area and Work with plug-ins in the Mixer.

SubBass creates two bass signals, derived from two separate portions of the incoming signal. These are defined with the High and Low parameters.

WARNING: Using SubBass can produce extremely loud output signals. Choose moderate monitoring levels, and only use loudspeakers that are actually capable of reproducing the very low frequencies produced. Never try to force a loudspeaker to output these frequency bands with an EQ.

Figure. SubBass window.

SubBass Low and High parameters

  •  Ratio Low knob and field: Adjust the ratio between the generated signal and the lower frequency band of the original signal.

  •  Center Low knob and field: Set the center frequency of the lower frequency band.

  • Bandwidth Low knob and field: Set the width of the lower frequency band.

  • Ratio High knob and field: Adjust the ratio between the generated signal and the upper frequency band of the original signal.

  • Center High knob and field: Set the center frequency of the upper frequency band.

  • Bandwidth High knob and field: Set the width of the upper frequency band.

  • Freq. Mix slider and field: Adjust the mix ratio between the low and high frequency bands.

SubBass Output parameters

  • Dry slider and field: Set the amount of dry (non-effect, original) signal.

  •  Wet control and field: Set the amount of wet (effect) signal.

Download this guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Χρήσιμο;
Όριο χαρακτήρων: 250
Το μέγιστο όριο χαρακτήρων είναι 250.
Σας ευχαριστούμε για τα σχόλια.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.