Logic Pro for iPad 3.3
Logic Pro for iPad 3.0
Logic Pro for iPad 2.2
Logic Pro for iPad 2.1
Logic Pro for iPad 2.0
Logic Pro for iPad 1.1
Logic Pro for iPad 1.0
Εάν τροποποιήσετε αυτό το χειριστήριο, θα γίνει αυτόματη ενημέρωση αυτής της σελίδας

Match EQ parameters in Logic Pro for iPad

Match EQ offers the parameters described in this section.

Figure. Match EQ window.

Match EQ parameters

  •  Current Material Learn button: Start or stop the process of learning the frequency spectrum of the project you want to match with the source file or input.

  • Reference Material Learn button: Start or stop the process of learning the frequency spectrum of the source file or input.

  • Crnt/Ref Actions pop-up menus: Choose and execute commands from either the Current or Reference Actions pop-up menu.

    • Clear Current Material/Reference Spectrum: Clears the Current Material Spectrum or Reference Spectrum.

    • Copy Current/Reference Spectrum: Copies the Current Material Spectrum or Reference Spectrum to the Clipboard.

    • Paste Current/Reference Spectrum: Pastes the Current Material Spectrum or Reference Spectrum from the Clipboard.

  • Match button: Match the frequency spectrum of the current material to that of the template (source) file.

  • Phase pop-up menu: Choose the operational principle of the filter curve.

    • Linear: Prevents processing from altering the signal phase, but latency is higher.

    • Minimal: Alters the signal phase (slightly), but latency is reduced.

    • Minimal, Zero Latency: Adds no latency, but has a higher CPU overhead than the other options.

  • Channel Link knob: Change the way the EQ curve is applied to stereo channels.

    • When set to 100%, both channels share a common EQ curve.

    • When set to 0%, a separate filter curve is applied for the left and right channel.

    • Settings between 0 and 100% blend these values with your filter curve changes for each channel. This results in a hybrid curve.

      Note: The Channel Link parameter is disabled when you use the effect on a mono channel.

  • Smoothing knob and field: Set the amount of smoothing for the filter curve, using a constant bandwidth set in semitone steps. A value of 0.0 has no impact on the filter curve. A value of 1.0 means a smoothing bandwidth of one semitone. A value of 4.0 means a smoothing bandwidth of four semitones (a major third). A value of 12.0 means a smoothing bandwidth of one octave, and so on.

    Note: Smoothing has no effect on any manual changes you make to the filter curve.

  •  Apply Amount slider and field: Determine the impact of the filter curve on the signal.

    • Values above 100% magnify the effect.

    • Values below 100% reduce it.

    • Negative values (−1% to −100%) invert the peaks and troughs in the filter curve.

    • A value of 100% has no impact on the filter curve.

  • Fade Extremes button: Select to set an automatic high cut and low cut threshold. Matching signals above or below these thresholds are slowly faded to zero.

  • Fade LF Bottom/Top sliders: Set the bottom and top frequencies for the filter curve that is applied to low frequency spectrum signals.

  • Fade HF Bottom/Top sliders: Set the bottom and top frequencies for the filter curve that is applied to high frequency spectrum signals.

Download this guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Χρήσιμο;
Όριο χαρακτήρων: 250
Το μέγιστο όριο χαρακτήρων είναι 250.
Σας ευχαριστούμε για τα σχόλια.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.