Logic Pro for iPad 3.3
Logic Pro for iPad 3.0
Logic Pro for iPad 2.2
Logic Pro for iPad 2.1
Logic Pro for iPad 2.0
Logic Pro for iPad 1.1
Logic Pro for iPad 1.0
Εάν τροποποιήσετε αυτό το χειριστήριο, θα γίνει αυτόματη ενημέρωση αυτής της σελίδας

Compressor output parameters in Logic Pro for iPad

Compressor output parameters are shown in the lower portion of the plug-in.

Figure. Compressor Output parameters.

Compressor output parameters

  • Limiter On/Off button: Turn the integrated limiter on or off. Limiting prevents the output of Compressor from exceeding the threshold value.

  • Threshold knob and field: Set the threshold level for the limiter.

  • Mix knob and field: Set the balance between dry (source) and wet (effect) signals. This allows you to either reduce signal peaks (dry), or to increase the level of softer signals (wet).

  • Output Gain knob and field: Set the overall level of the compressor output.

  • Distortion buttons: Choose whether to apply clipping above 0 dB, and the type of clipping. Soft, Hard, and Clip reduce the signal around the 0 dB line in different ways, resulting in a smoothed or squared off distortion of the signal peaks. Experiment with these options

    • Off: Stop all clipping.

    • Soft: Rounds off the signal as it approaches the 0 dB level, reducing the overall signal, rather than abruptly limiting amplitude.

    • Hard Emulates a transistor effect that abruptly limits amplitude above 0 dB.

    • Clip: Limits amplitude at the 0 dB mark, but can be more punchy than the Hard setting, depending on the input material.

Download this guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Χρήσιμο;
Όριο χαρακτήρων: 250
Το μέγιστο όριο χαρακτήρων είναι 250.
Σας ευχαριστούμε για τα σχόλια.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.