Logic Pro for Mac 12.3
Logic Pro for Mac 12.2
Logic Pro for Mac 12.0
Logic Pro for Mac 11.2
Logic Pro for Mac 11.1
Logic Pro for Mac 11.0
Logic Pro for Mac 10.8
Logic Pro for Mac 10.7.8
Logic Pro 10.7.5
Logic Pro 10.7.3
Logic Pro 10.7
Logic Pro 10.6.2
Logic Pro 10.6
Logic Pro X 10.5
Εάν τροποποιήσετε αυτό το χειριστήριο, θα γίνει αυτόματη ενημέρωση αυτής της σελίδας

Ultrabeat ring modulator in Logic Pro for Mac

Ring modulation is a powerful tool for the creation of inharmonic, metallic, bell-like sounds. The Ultrabeat ring modulator functions as an independent sound source—its signal can bypass or be sent into the filter, independent of the oscillator 1 and 2 signals. Its volume can also be regulated.

Important: Although the ring modulator signal is independent of the signals generated by oscillators 1 and 2, both oscillators need to be turned on if you want to use the ring modulator signal. Because the ring modulator is reliant on the signals of both oscillators to produce an output signal, it is automatically muted when one of the oscillators is switched off.

The actual sound produced by the ring modulator is largely dependent on the parameter settings of both oscillators. In particular, the tuning relationships of each oscillator have a direct effect on the sound of the ring modulator signal. The individual levels of the oscillators, however, have no effect on the process (or output) of ring modulation.

Figure. Ring Modulator.

Ring modulator parameters

  • Ring Modulator On/Off button: Turn the ring modulator on or off.

    Note: If you want to hear the ring modulator signal in isolation (to better judge your settings), temporarily set the volume of both oscillators to a value of 0.

  • Level slider: Set the output volume of the ring modulator.

  • Mod and via pop-up menus: Choose the modulation source (and optional via source) for the Level parameter. When either source is active, small sliders (handles) appear on either side of the Level slider. See Ultrabeat modulation overview.

  • Signal Flow button: Determine the routing of the ring modulator signal to the filter (red) or to the EQ section (gray). The direction of the arrow on the Signal Flow button illustrates the routing.

    Note: The Signal Flow button determines how the ring modulator output signal is routed. It doesn’t turn the ring modulator on or off.

Download the guides:

Logic Pro User Guide: PDF

Logic Pro Instruments: PDF

Logic Pro Effects: PDF

Control Surfaces Support Guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Χρήσιμο;
Όριο χαρακτήρων: 250
Το μέγιστο όριο χαρακτήρων είναι 250.
Σας ευχαριστούμε για τα σχόλια.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.