Motion 6.3
Motion 6.0
Motion 5.11
Motion 5.10
Motion 5.9
Motion 5.8
Motion 5.7
Motion 5.6.6
Motion 5.6.4
Motion 5.6.1
Motion 5.6
Motion 5.5.2
Motion 5.5.1
Motion 5.5
Motion 5.4.6
Motion 5.4.4
Po úpravě tohoto prvku se tato stránnka automaticky zaktualizuje

Adjust additional replicator properties in Motion

You can modify a replicator’s position, scale, blend mode, drop shadow, and other basic attributes in the Properties Inspector. These properties are separate from the replicator parameters in the Replicator and Replicator Cell Inspectors, which control the shape and size of the replicator, as well as all aspects of its pattern and cells.

  1. In Motion, select a replicator in the Layers list, Timeline, or canvas.

  2. In the Inspector, click Properties.

  3. Adjust the controls.

For detailed information about the Properties Inspector, see Properties Inspector controls in Motion.

Note: When you select a replicator cell (as opposed to the replicator, itself) and open the Properties Inspector, only one group of parameters is available: the Timing controls, which adjust the In and Out points of the replicator cell.

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Užitečné?
Limit počtu znaků: 250
Limit maximálního počtu znaků je 250.
Děkujeme za zpětnou vazbu.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.