11.2
11.0
10.7.3
10.6
10.5
Po úpravě tohoto prvku se tato stránnka automaticky zaktualizuje

Yamaha DM1000 Insert display mode in Logic Pro

Press the F2 button to select Insert display mode. In this mode, the LCD displays parameters, allowing you to edit effects. This mode also allows you to switch between different Insert slots, enabling each effect to be edited.

Control

Assignment

COMPARE

Switches the display between “track name/parameter name” and “parameter name/parameter value” modes.

BYPASS

Switches the bypass state of plug-in currently being edited.

INSERT/PARAM

Switches between Plug-in Assign and Plug-in Edit modes.

Selecting virtual encoders 1 to 4 (Use cursor keys, and then press ENTER button.)

Pan Assignment mode:

  • Parameter control 1 button centers pan or surround angle.

  • Parameter control 2 button centers surround diversity.

  • Parameter control 3 button resets surround LFE level.

  • Parameter control 4 button resets spread.

Send Assignment mode:

  • Enables or disables Sends 1 to 4 or 5 to 8.

Plug-in Assignment mode:

  • Confirms the plug-in selection for Insert slots 1 to 4 or 5 to 8, and enters Plug-in Edit mode for the selected Insert slot.

Plug-In Edit mode:

  • Sets value to default, or switches buttons with two states.

Moving virtual encoders 1 to 4 (Use cursor keys, and then rotate parameter wheel.)

Pan Assignment mode:

  • Parameter control 1 edits pan or surround angle.

  • Parameter control 2 edits surround diversity.

  • Parameter control 3 edits surround LFE level.

  • Parameter control 4 edits spread.

Send Assignment mode:

  • Controls the Send level of Sends 1 to 4 or 5 to 8.

Plug-in Assignment mode:

  • Chooses Insert slot 1 to 4 or 5 to 8.

Plug-in Edit mode:

  • Sets value.

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Užitečné?
Limit počtu znaků: 250
Limit maximálního počtu znaků je 250.
Děkujeme za zpětnou vazbu.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.