11.2
11.0
10.7.3
10.6
10.5
Po úpravě tohoto prvku se tato stránnka automaticky zaktualizuje

Mackie Control Instrument edit view in Logic Pro

In this view, you can edit instrument parameters.

Note: Mackie Control can edit all instruments that can be automated, regardless of the type of plug-in you are using (Logic Pro native or Audio Units). Some third-party manufacturer instruments do not provide parameter names or values as text. In such cases, parameters are named and enumerated as “Control #1,” “Control #2,” and so on, with values displayed as numbers ranging between 0 and 1000. Contact the plug-in manufacturer to obtain a version that supports this feature.

In Instrument edit view:

  • The mode display shows “In.”

  • Depending on the state of the NAME/VALUE button, the LCD changes in the following ways:

    • Name: The upper LCD row shows the channel strip name, instrument name, current parameter page, and total number of parameter pages. The lower LCD row shows the name of the parameter that can be edited with the V-Pot directly below.

    • Value: The upper LCD row shows the name of the parameter that can be edited with the V-Pot below. The lower LCD row shows the current value of the parameter being edited. If there is sufficient space on the LCD row, the unit type is shown after the value; for example, Hz or dB.

  • Rotating a V-Pot changes the corresponding parameter.

  • Pressing a V-Pot button sets the parameter to its default value, except when the parameter only has two values (on/off, for example). In this case, pressing the V-Pot button switches between these values.

Download the guides:

Logic Pro User Guide: PDF

Logic Pro Instruments: PDF

Logic Pro Effects: PDF

Control Surfaces Support Guide: PDF

Morty Proxy This is a proxified and sanitized view of the page, visit original site.
Užitečné?
Limit počtu znaků: 250
Limit maximálního počtu znaků je 250.
Děkujeme za zpětnou vazbu.
Morty Proxy This is a proxified and sanitized view of the page, visit original site.