A 3d printable case for the Raspberry Pi.

• Case Bottom: Print in normal orientation, generate support for the SD card slot, power port, and exterior pins.
• Case Top: Print inverted, generate support for the camera mount slot and inside the hinges. Be sure that support is not generated in the camera cable slot.
• Camera Mount: Print with the back face down, generate support tab that mounts into the case top.
• Camera Case: Print with the front face down, no support needed.
• Case Lid: Print inverted, no support needed.
• Rain Shield: Print in normal orientation, generate support under then the mounting arms and support bracket.

The camera case is attached to the mount using 1" or longer 4-40 screws.